Question: How Can I Make A Wireless Remote?

How can I make a wireless transmitter and receiver?

Wireless Power Transmitter and ReceiverStep 1: Transmitter Schematic.

The transmitter uses a BD139 transistor, a few capacitors, a resistor and 2 turns, 6cm diameter of #18AWG magnet wire tapped at the center.

Step 2: Breadboard and Blurry Scope Shot.

Step 3: Receiver Schematic.

Step 4: PCB Design.

Step 5: Assembly.

Step 6: Power Up.

13 Discussions..

How can I make a wireless remote control drone at home?

Step-by-Step InstructionsStep 1: Making the Frame. … Step 2: Propellers, Electronic Speed Controllers, and Motors. … Step 3: Assemble the Motors. … Step 4: Mount the Electronic Speed Controllers. … Step 5: Add the Landing Gear. … Step 6: Flight Controller. … Step 7: Choosing a Right RC Tx-Rx (Wireless Remote Control System)More items…

What is a remote switch?

A remote electrical switch is a convenient way to turn on lights and small electrical appliances from locations inside or outside the home. Using a remote electric switch makes it easy to illuminate the house from your car or garage, reducing the risk of falls or fumbling for light switches in the dark.

How do you make a light circuit?

What You Need:Small light bulb (or a flashlight bulb)2 batteries (with the correct voltage for your light bulb)2 alligator clip wires or aluminum foil*Paper clips.Electrical tape (Scotch®tape also works)Bulb holder (optional)Battery holders (optional**)

How do you make a remote control fan light?

Step 2: Understanding the Relay Module In my module too, from left to right- the 3 pins are: NC (normally connected), COM (common), NO (normally open). Connect the live wire to the bulb as shown. You can solder the entire project and install it inside your switch board to control your tubelight, fan, lamp etc.

How can I make remote control plane at home?

How to Make RC PlaneStep 1: What You Need? Electronic parts: … Step 2: Forces Acting on an RC Plane. … Step 3: My Fuselage. … Step 4: Controlling Flight and Some Words About Servos. … Step 5: Servos Mounting. … Step 6: Motor, Propeller, ESC and Battery. … Step 7: Making Receiver and Mounting All Stuffs in the Fuselage. … Step 8: Transmitter.More items…